Re: [CAD_CAM_EDM_DRO] Why is a Gcode standard important???

Are you correct, is G01 not accepted by almost all controllers as linear
move at feed rate? Is not G00 a linear move at rapid? I spent nearly 30
years in manufacturing and believe that the majority of responsible machine
controller manufacturers do follow the standard. Of course there are a
number that for their own reasons of insecurity invent there own standards.

----- Original Message -----
From: "Brian Pitt" <bfp@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Tuesday, December 25, 2001 6:38 PM
Subject: Re: [CAD_CAM_EDM_DRO] Why is a Gcode standard important???


>
> well the cold hard fact is that the so called "standard" isn't worth
> the paper its printed on and it does not matter even one little bit.
>
> there is not and has never been a machine control that used
> this "PURE" standard in the first place ,the document itself is
> full of loopholes and leaves so much up to the control builder
> that no one can guess what the "real standard" should be anyway
> all in all thats not much of a standard after FIFTY YEARS of trying ;-)
>
> Brian
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>