RE: [CAD_CAM_EDM_DRO] serial cable current capabilities

~
~Hi Scot,
~
~I'm using DB15's (I had a lot of 'em), and they work fine. Trouble is
~getting 18 ga. wire into the pins! You can also use a PAIR of wires and
~pins per lead. I have quite a few motors wired with DB15's. Even
~Unipolar motors, where I use an additional pair of pins for the "common"
~(2nd common for 6 wire motors). The common pins are ignored for a
~bipolar motor. I was even thinking of adding the current selection
~resistor to the connector as well. BUT, I'd caution that you provide a
~"minimum current" resistor at the Gecko. Otherwise, well you know what
~will happen!
~
~Alan KM6VV


Thanks Alan,

One question though. *Each* of the motors draw 3.3 amps. Does that change
anything?