Re: serial cable current capabilities

>
> Hello,
>
> I've got a good one for Db9's.
>
> Ballendo
>
> --- In CAD_CAM_EDM_DRO@y..., Alan Marconett KM6VV <KM6VV@a...> wrote:
> > Hi Randy,
> >
> > Maybe the list needs to settle on a pinout spec (for us hobby
> types)!
> >
> > Alan KM6VV
> >
> >
> > Randy Gordon-Gilmore wrote:
> > >
> > > At 03:03 PM 1/9/2002 -0800, Alan Marconett KM6VV wrote:
> > >
> > > >Another good connector that's been suggested is a "microphone"
> connector
> > > >(Radio Shack), as used on communications gear. And I've just
> > >
> > > I'm using those (4-pin) and like them. The pins will accomodate
> 16-gage
> > > wire too. (I would've settled for 22-gage for my little Sherline
> motors,
> > > but the surplus place didn't have that size of Infinity
> Cable...) I did
> > > need to remove the clamp from the back of the plugshell and bore
> the hole
> > > larger to accomodate the larger cable, though.
> > >
> > > I'll also be using an 8-pin microphone plug (also from Radio
> Shack) to wire
> > > in limit and home switches, now that my controller is to be
> shared between
> > > the Sherline mill and (in-process) lathe.
> > >
> > > Best regards,
> > >
> > > Randy
> > >
> > > Randy Gordon-Gilmore ,----.___________ ______________
> _________________
> > > ProtoTrains // = = === == || == == == = || == ==
> == = == =|
> > > Rio Vista, CA, USA /-O==O------------o==o------------o==o--------
> ---o==o-'
> > > zephyrus@r... http://www.rickadee.net/~zephyrus
> > >
>