Re: [CAD_CAM_EDM_DRO] BobCAD users
Posted by
Keith Rumley
on 2002-01-24 16:57:41 UTC
Alex,
Your outside toolpath is most likely coming around and ending at the start
point....
Usually this can be fixed quickly by zooming in and doing a 'trim to
screen' and extending or shortening the end path.
If you have a small gap you might try the making your chain tolerance
smaller. (CAD preferences, I believe)
- Keith
_________________________________________________________
Do You Yahoo!?
Get your free @... address at http://mail.yahoo.com
Your outside toolpath is most likely coming around and ending at the start
point....
> all the way down plus .002". It overlaps it previous path by .010" and itneed
> describes a spiral path starting from the center and going outwards. The
> problem is that when it gets to the last spiral path it keeps going and
> going and going kinda like the energizer bunny.
>
> What can I do to fix this problem in NCcam. Is there a variable that I
> to change?Zoom in on the place where the spiral joins the outside path to check
Usually this can be fixed quickly by zooming in and doing a 'trim to
screen' and extending or shortening the end path.
If you have a small gap you might try the making your chain tolerance
smaller. (CAD preferences, I believe)
- Keith
_________________________________________________________
Do You Yahoo!?
Get your free @... address at http://mail.yahoo.com
Discussion Thread
Russell Shaw
2002-01-23 22:41:57 UTC
Maximum stepper speed
mariss92705
2002-01-24 08:26:00 UTC
Re: Maximum stepper speed
Jon Elson
2002-01-24 10:50:58 UTC
Re: [CAD_CAM_EDM_DRO] Maximum stepper speed
Alex Canale
2002-01-24 11:09:29 UTC
RE: [CAD_CAM_EDM_DRO] BobCAD users
Russell Shaw
2002-01-24 16:12:14 UTC
Re: [CAD_CAM_EDM_DRO] Re: Maximum stepper speed
Keith Rumley
2002-01-24 16:57:41 UTC
Re: [CAD_CAM_EDM_DRO] BobCAD users
mariss92705
2002-01-24 19:31:52 UTC
Re: Maximum stepper speed
Raymond Heckert
2002-01-24 19:56:21 UTC
Re: [CAD_CAM_EDM_DRO] BobCAD users
ballendo
2002-01-25 03:20:16 UTC
Re: BobCAD users
Alex Canale
2002-01-25 05:21:15 UTC
RE: [CAD_CAM_EDM_DRO] Re: BobCAD users
Alex Canale
2002-01-25 05:57:45 UTC
RE: [CAD_CAM_EDM_DRO] BobCAD users
James Stevens
2002-01-25 07:13:00 UTC
Re: [CAD_CAM_EDM_DRO] BobCAD users
stevenson_engineers
2002-01-25 13:45:54 UTC
Re: BobCAD users
Alex Canale
2002-01-25 16:10:43 UTC
RE: [CAD_CAM_EDM_DRO] Re: BobCAD users