Re: Re: COREL DRAW 10

--- In CAD_CAM_EDM_DRO@y..., Chris L <datac@l...> wrote:

> Hey Fred,
>
> Well, Most of what you say IS, "because" Vector is such a good

program !

> You bring up a very good point. Vector just may be one of the few

programs that CAN handle a Corel DXF !

>
> I did notice that Vector is quite tolerable with screwed up files

from other programs. Corel DXF export filters have been some of the
worst. Vector has the ability to get rid of the duplicates and also
it seems to be able to get the arcs going the right way. I have seen
Corel DXF files brought in to other programs that were in absolute
shambles.

>
> The new Metafile import is very interesting. I never used Metafiles

in the past as for some reason I thought they were raster. And, I
have to admit, short of bringing one into Vector once, I have not
done it since. But it did do a nice job.

>

In Corel, Edit Copy
In Vector, Edit-Paste Special, Metafile Geometry.

Scaled and located, ready to cut.

> In regards the hpgl "print driver", is this a driver offered by

Corel ?


Standard Windows. Look under HP in the printer drivers under install
printer. You will see at least 5 different HP plotters included.
Try the HP7475A.


Best Regards, Fred Smith- IMService

Listserve Special discounts and offers are at:
http://www.vectorcam.com/cced2.html

We are THE source for low cost Cad Cam