CAD CAM EDM DRO - Yahoo Group Archive

Re: Gecko's don't like 7 x 10

Posted by cdoughtynz
on 2002-03-02 00:30:34 UTC
I have checked and rechecked the trimpots and they are set ok,
everything runs very smooth and quite except for this one ratio.
Colin

--- In CAD_CAM_EDM_DRO@y..., JanRwl@A... wrote:
> In a message dated 01-Mar-02 00:39:37 Central Standard Time,
> cdoughty@p... writes:
>
>
> > Has any one else experienced this? Is there a fix?
> >
>
> Colin: I may be all-wrong, but I THINK this may be a SUPER-simple
fix!
> Look at your Geckos: There is the word "ADJUST" in the upper-
left. That is
> a "hint" that there is a TRIM-POT under that word. There is a hold
for a
> small screwdriver on the "top side" right above the word ADJUST,
and
> amazingly, it will CHANGE the "nasty sound" the motors do when
fiddling with
> things "temporarily hooked up in the bench, just to see". I have
not
> assembled my first "Gecko-driven machine", yet, but I DID have the
two
> steppers turning with pointer-knobs attached to their shafts, "to
see", and
> all is just wunnerful!
>
> TRY it! You'll LIKE it! Jan Rowland, the old troll
>
>
> [Non-text portions of this message have been removed]

Discussion Thread

cdoughtynz 2002-02-28 22:38:03 UTC Gecko's don't like 7 x 10 ballendo 2002-03-01 01:53:20 UTC Re: Gecko's don't like 7 x 10 mariss92705 2002-03-01 07:23:03 UTC Re: Gecko's don't like 7 x 10 studleylee 2002-03-01 08:49:40 UTC Re: Gecko's don't like 7 x 10 (stepper resonance) Jon Elson 2002-03-01 10:27:55 UTC Re: [CAD_CAM_EDM_DRO] Gecko's don't like 7 x 10 mariss92705 2002-03-01 10:52:08 UTC Re: Gecko's don't like 7 x 10 (stepper resonance) stephen_stallings 2002-03-01 11:13:37 UTC Re: Gecko's don't like 7 x 10 (stepper resonance) JanRwl@A... 2002-03-01 19:42:58 UTC Re: [CAD_CAM_EDM_DRO] Gecko's don't like 7 x 10 JanRwl@A... 2002-03-01 19:46:03 UTC Re: [CAD_CAM_EDM_DRO] Gecko's don't like 7 x 10 cdoughtynz 2002-03-02 00:30:34 UTC Re: Gecko's don't like 7 x 10