CAD CAM EDM DRO - Yahoo Group Archive

Re: Denford Triac Milling Machine

Posted by mart_wid
on 2002-03-29 11:02:57 UTC
> The Triac came in a few different guises with variations on the
> controller - I have a 1985 vintage one which I have sucessfully
got
> talking to a PC using Hyperterminal (part of Win 98), but you have
to
> top and tail everthing with 'EOT' characters (control Z iirc).
>
> I am shortly going to pull out all the drive electronics from mine
> and install a PC running EMC - the PC is up and running, the Gecko
> drivers are bought - just not got round to finishing installation !
>
> Andrew Mawson
> Bromley,
> Kent,
> UK

Hi Andrew,
Thanks for the swift reply.
Mine is an 1985 model with North East Electronics interface. I use
Dolphin CadCam for programming so the extra control characters may
not be a problem if I can figure out how to get them into a post-
processor (not my strong point). Do you have any details on wiring
the plugs and how to set the software? Any help would be much
appreciated.

Thanks, Martin.
Nottingham,
UK.

PS have you tried TurboCNC? I'm thinking of using it with a Denford
Starturn lathe and am interested in your views.

Discussion Thread

mart_wid 2002-03-29 10:26:09 UTC Denford Triac Milling Machine awemawson 2002-03-29 10:38:38 UTC Re: Denford Triac Milling Machine mart_wid 2002-03-29 11:02:57 UTC Re: Denford Triac Milling Machine Paul 2002-03-29 12:31:04 UTC Re: [CAD_CAM_EDM_DRO] Denford Triac Milling Machine awemawson 2002-03-29 15:42:59 UTC Re: Denford Triac Milling Machine