Re: [CAD_CAM_EDM_DRO] cap question

Hi ... not an expert on this, but I believe your voltage on your cap may be
too low, and I think it's better to over cap than to not have enough.

Russ

----- Original Message -----
From: Mike Snodgrass <snarf@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Monday, April 01, 2002 2:43 PM
Subject: [CAD_CAM_EDM_DRO] cap question


> Hello, on my on-going power supply project, I am putting
> together a 25A unit. By using a rough estimate of 1000mf
> per A load, I need 25000mf. I have a 33000mf 60V cap. The output of my
trans is 58V. Is there anyway to "trim"
> 8000mf? How much overfiltering can be tolerated?
>
> Thanx
> Mike
>
>
> [Non-text portions of this message have been removed]
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this as a
sister site to the CCED group, as many of the same memembers are there, for
OT subjects, that are not allowed on the CCED list.
>
>
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>