CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] cutting glass ? and router costs

on 2002-06-20 01:29:08 UTC
On Thu, 20 Jun 2002 01:37:36 -0000, you wrote:


>first, has anyone cut glass on a CNC table ?
>is it worth the effort ?
>
>I'm looking at odd shapes for stained glass windows.

It's cut like that when manufactured, but only straight cuts.

As the glass leaves the lehr annealer it's still in a continuous
ribbon, it's cut on the move by a traversing head - it's good to watch
as the glass is moving, the cutter moves diagonally to keep the cut
straight. It's sometimes cut again down the line into smaller sheets.

These cuts merely score the surface, the break is done mechanically.
(Differing conveyor levels - it snaps under its own weight or a
breaker bar - depending on size)

You "may" be able to do the fancy shapes using a spring loaded single
point diamond tool then breaking by hand, but unless your mass
producing the same design on flat glass, a good man with a wheel or
diamond will outperform you.

A lot of the stained glass stuff I've seen uses rough glass that is
difficult to cut by hand. Unless you were using some sort of laser
would be very difficult by machine.



Steve Blackmore
--
Pilot Consultancy Limited ***** Computer Consultants
Telephone 01744 752256 Mobile 07831 768478
Email: steve@... WWW: http://www.pilotltd.net

Discussion Thread

turbulatordude 2002-06-19 18:37:38 UTC cutting glass ? and router costs Paul Amaranth 2002-06-19 19:50:47 UTC Re: [CAD_CAM_EDM_DRO] cutting glass ? and router costs Jon Elson 2002-06-19 20:00:57 UTC Re: [CAD_CAM_EDM_DRO] cutting glass ? and router costs armadhas 2002-06-19 20:22:10 UTC Re: cutting glass ? and router costs John Brautlacht 2002-06-19 20:55:22 UTC Re: [CAD_CAM_EDM_DRO] cutting glass ? and router costs Elliot Burke 2002-06-19 22:34:18 UTC re:cutting glass ? and router costs bsptrades 2002-06-20 01:01:31 UTC Re: cutting glass ? and router costs Steve Blackmore 2002-06-20 01:29:08 UTC Re: [CAD_CAM_EDM_DRO] cutting glass ? and router costs ballendo 2002-06-20 03:32:27 UTC Re: cutting glass ? and router costs Dave Lantz 2002-06-20 05:15:53 UTC RE: [CAD_CAM_EDM_DRO] cutting glass ? and router costs turbulatordude 2002-06-20 06:33:35 UTC Re: cutting glass ? and router costs Bob Campbell 2002-06-20 06:45:01 UTC RE: [CAD_CAM_EDM_DRO] cutting glass ? and router costs Thomas Mayfield 2002-06-20 09:21:56 UTC Re: cutting glass ? and router costs CL 2002-06-20 11:40:31 UTC Re: [CAD_CAM_EDM_DRO] cutting glass ? and router costs Cardinal.Eng 2002-06-21 18:20:39 UTC Re: cutting glass ? and router costs