CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] steppers

Posted by JanRwl@A...
on 2002-07-25 20:18:49 UTC
In a message dated 25-Jul-02 22:11:12 Central Daylight Time,
capper@... writes:


> They say DC 4.5A- 0.47oms/phase. how many volts would that be?
>

Ohm's Law says E=I·R. So, 4.5 x 0.47 = 2.115 Volts per winding. That sounds
like a nice Low-L motor which should have respectable torque at good speed.
It is a "Size 34", right???


[Non-text portions of this message have been removed]

Discussion Thread

Gene 2002-07-10 00:00:20 UTC steppers stevenson_engineers 2002-07-10 00:56:02 UTC Re: steppers Tim Goldstein 2002-07-10 09:31:51 UTC Re: [CAD_CAM_EDM_DRO] steppers Jon Elson 2002-07-10 10:08:32 UTC Re: [CAD_CAM_EDM_DRO] steppers Steve Blackmore 2002-07-10 11:55:19 UTC Re: [CAD_CAM_EDM_DRO] steppers Jon Elson 2002-07-10 20:24:00 UTC Re: [CAD_CAM_EDM_DRO] steppers Gene 2002-07-11 00:11:10 UTC steppers Gene 2002-07-11 00:44:39 UTC steppers Joll503@A... 2002-07-11 01:32:19 UTC Re: [CAD_CAM_EDM_DRO] steppers jmkasunich 2002-07-11 07:34:41 UTC Re: steppers mariss92705 2002-07-11 09:24:54 UTC Re: steppers jmkasunich 2002-07-11 09:32:32 UTC Re: steppers Jon Elson 2002-07-11 10:04:43 UTC Re: [CAD_CAM_EDM_DRO] Re: steppers Jon Elson 2002-07-11 10:06:10 UTC Re: [CAD_CAM_EDM_DRO] Re: steppers Tony Jeffree 2002-07-11 11:39:29 UTC Re: steppers Gene 2002-07-25 20:09:50 UTC steppers JanRwl@A... 2002-07-25 20:18:49 UTC Re: [CAD_CAM_EDM_DRO] steppers Gene 2002-07-25 20:21:18 UTC Re: [CAD_CAM_EDM_DRO] steppers Jon Elson 2002-07-25 21:13:09 UTC Re: [CAD_CAM_EDM_DRO] steppers kilroy2k1 2002-07-26 14:51:10 UTC Re: steppers Bailey, Paul R 2002-07-26 22:39:32 UTC RE: [CAD_CAM_EDM_DRO] Re: steppers Gene 2003-02-14 13:23:42 UTC steppers