Re: L298 goes boom on my camtronics :(

Hi Tauseef,
I was pretty sure, but I just now checked to make sure, and I am
using a single pole single throw switch to enable/disable all four
axis and it works fine. It comes off J8 on the main board. There is
an eight pin connector J1 on the fourth axis board that that ties it
to the main board. One of the pins is marked 'enable'. I don't
remember exactly where it ties into the main board, but Dan's
instructions must have covered it or else I couldn't have wired it up
in the first place. If need be, I can open up the box and trace out
the J1 connections, if it would help.
Al