Re: [CAD_CAM_EDM_DRO] Need Zero Help!!

Only problem with this solution is that on the BDI the G92 offsets are not
always persistent. That is the reason I do not use it and stick with the old
RH 5.2 install instead. The other way to do it is on manual mode right click
on the display coordinate for the axis and enter the desired position into
the box. It is actually doing a G92 so you do have the same persistence
issues. Keep spare shorts handy for the first time it decides to cancel the
offset and return to the original 0. Happened to me twice with an 8"
slotting blade diving for the table and it was rapidly BDI out of my shop.

Tim
[Denver, CO]
NEMA 23 steppers and E-Stop buttons
www.KTMarketing.com/CNC.html

----Original message -----
Hi Ed,

Have you tried a "G92 X0 Y0 Z0" MDI command?

Alan KM6VV

EdFanta wrote:

>
> Hope I'm not the zero here. I got EMC up and running finally and cannot
> seem to figure out how to set the readouts to zero. If I'm edge finding
> the corner of my vise I need to set zero. It's probably so obvious that
> I can't see it. Thanks. Ed.