Hand wheels and Geckos
Posted by
High Tech
on 2002-10-06 23:14:16 UTC
Hello all,
I can't remember what has been said about this subject and I looked through
the 20,000 emails on my computer.
Question when you turn off the power supply to use the mill manually, is
there a problem with having it back feed energy back into the drives by
turning the hand wheels?
Will this hurt the drives? Would it matter if the stepper is in parallel or
series?
Derek B.
High Tech Systems
Denver, Co.
I can't remember what has been said about this subject and I looked through
the 20,000 emails on my computer.
Question when you turn off the power supply to use the mill manually, is
there a problem with having it back feed energy back into the drives by
turning the hand wheels?
Will this hurt the drives? Would it matter if the stepper is in parallel or
series?
Derek B.
High Tech Systems
Denver, Co.
Discussion Thread
Brent Fuchs
2002-10-06 18:38:23 UTC
PID setting in EMC
mariss92705
2002-10-06 19:47:45 UTC
Re: PID setting in EMC
Tim Goldstein
2002-10-06 20:02:34 UTC
RE: [CAD_CAM_EDM_DRO] Re: PID setting in EMC
High Tech
2002-10-06 23:14:16 UTC
Hand wheels and Geckos
Ray Henry
2002-10-07 05:24:56 UTC
Re: PID setting in EMC
vrsculptor
2002-10-07 05:53:05 UTC
Re: Hand wheels and Geckos
dakota8833
2002-10-07 06:31:31 UTC
Re: PID setting in EMC
Rick E
2002-10-07 07:47:51 UTC
Re: [CAD_CAM_EDM_DRO] Re: PID setting in EMC
Tim Goldstein
2002-10-07 09:35:46 UTC
Re: [CAD_CAM_EDM_DRO] Re: PID setting in EMC
skykotechnologies
2002-10-07 09:54:10 UTC
Re: PID setting in EMC
Rick E
2002-10-07 12:16:38 UTC
Re: [CAD_CAM_EDM_DRO] Re: PID setting in EMC
William Scalione
2002-10-07 13:53:19 UTC
Re: [CAD_CAM_EDM_DRO] Re: PID setting in EMC