Re: Re: RS-274 spec

Paul Corner wrote:

> From: Paul Corner <Paul.Corner@...>
>
>
> > From: Jon Elson <jmelson@...>
> > Far more useful is ANY book on CNC programming or the programmer's
> guide
> > for any
> > recent CNC control.
>
> Heidenhain have been giving out F.O.C. a CD with programming manuals
> for eight
> of their current CNC controls. A useful disk if you can blag one.
> Ask for the TNCguide.

Oh, oh! Does Heidenhain use RS-274D as the command language? I was
under the
impression that they did not! Perhaps that is old information.

Jon