Re: Hi I'm new
Posted by
volitan712003 <volitan@o...
on 2002-12-08 06:48:45 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Jon Elson <elson@p...> wrote:
I have done hours of reading since my first post, and I've narrowed
my focus a bit. I found two tiny steppers in an old word processor. I
think I'll try to find something cheap to drive them just so I
can "play" for awhile before I move on to doing any kind of
conversion.
David
> Yes, it is a step/direction stepper driver. But, the motors areVERY
> small for a machinewant
> tool. You need a power supply in addition to all this. If you
> larger motors later, youThanks for looking at that for me.
> will probably need to replace the drivers.
>
> Jon
I have done hours of reading since my first post, and I've narrowed
my focus a bit. I found two tiny steppers in an old word processor. I
think I'll try to find something cheap to drive them just so I
can "play" for awhile before I move on to doing any kind of
conversion.
David
Discussion Thread
volitan712003 <volitan@o...
2002-12-07 17:58:57 UTC
Hi I'm new
volitan712003 <volitan@o...
2002-12-07 18:33:37 UTC
Re: Hi I'm new
Carol & Jerry Jankura
2002-12-07 18:35:41 UTC
RE: [CAD_CAM_EDM_DRO] Hi I'm new
volitan712003 <volitan@o...
2002-12-07 19:51:07 UTC
Re: Hi I'm new
Chris L
2002-12-07 19:52:28 UTC
Re: [CAD_CAM_EDM_DRO] Hi I'm new
Carol & Jerry Jankura
2002-12-07 22:00:59 UTC
RE: [CAD_CAM_EDM_DRO] Hi I'm new
Carol & Jerry Jankura
2002-12-07 22:01:02 UTC
RE: [CAD_CAM_EDM_DRO] Re: Hi I'm new
Jon Elson
2002-12-07 22:21:48 UTC
Re: [CAD_CAM_EDM_DRO] Hi I'm new
Chris L
2002-12-07 23:07:02 UTC
Re: [CAD_CAM_EDM_DRO] Hi I'm new
volitan712003 <volitan@o...
2002-12-08 06:09:32 UTC
Re: Hi I'm new
volitan712003 <volitan@o...
2002-12-08 06:36:13 UTC
Re: Hi I'm new
Brian
2002-12-08 06:40:17 UTC
Re: [CAD_CAM_EDM_DRO] Hi I'm new
volitan712003 <volitan@o...
2002-12-08 06:48:45 UTC
Re: Hi I'm new
Ray Henry
2002-12-08 08:23:03 UTC
Re: RE: Re: Hi I'm new
jim davies
2002-12-08 08:31:21 UTC
Re: [CAD_CAM_EDM_DRO] Re: Hi I'm new
Chris L
2002-12-08 09:03:17 UTC
Re: [CAD_CAM_EDM_DRO] Re: Hi I'm new