CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Stepper control w/o a computer?????

Posted by Tony Jeffree
on 2003-01-02 16:01:44 UTC
At 18:45 02/01/2003 -0500, Garry & Maxine Foster wrote:
>And the Sherlines have a cable(pigtal) so you can use then as the
>stepper driver in a cnc operation. I didn't realize this until
>yesterday.

DivisionMaster can generate step-and-direction signals to drive an external
controller (e.g., a Gecko G210), and can also act as a "slave" driven by
external step-and-direction signal generator (e.g., a PC).

Regards,
Tony

Discussion Thread

fozzyber <jerry@o... 2003-01-02 11:26:24 UTC Stepper control w/o a computer????? fozzyber <jerry@o... 2003-01-02 11:26:26 UTC Stepper control w/o a computer????? Tim Goldstein 2003-01-02 11:54:39 UTC Re: [CAD_CAM_EDM_DRO] Stepper control w/o a computer????? aussiedude 2003-01-02 12:14:36 UTC RE: [CAD_CAM_EDM_DRO] Stepper control w/o a computer????? Alan Marconett KM6VV 2003-01-02 12:16:44 UTC Re: [CAD_CAM_EDM_DRO] Stepper control w/o a computer????? Garry & Maxine Foster 2003-01-02 12:35:59 UTC Re: [CAD_CAM_EDM_DRO] Stepper control w/o a computer????? fozzyber <jerry@o... 2003-01-02 13:54:46 UTC Re: Stepper control w/o a computer????? Tony Jeffree 2003-01-02 14:42:28 UTC Re: Stepper control w/o a computer????? Tony Jeffree 2003-01-02 15:13:01 UTC Re: Stepper control w/o a computer????? Garry & Maxine Foster 2003-01-02 15:48:30 UTC Re: [CAD_CAM_EDM_DRO] Re: Stepper control w/o a computer????? Tony Jeffree 2003-01-02 16:01:44 UTC Re: [CAD_CAM_EDM_DRO] Re: Stepper control w/o a computer????? Ray Henry 2003-01-03 16:50:20 UTC Re: Re: Re: Stepper control w/o a computer????? JanRwl@A... 2003-01-03 16:56:43 UTC Re: [CAD_CAM_EDM_DRO] Stepper control w/o a computer????? Dan Mauch 2003-01-03 19:06:16 UTC RE: [CAD_CAM_EDM_DRO] Stepper control w/o a computer????? fozzyber <jerry@o... 2003-01-03 20:38:50 UTC Re: Stepper control w/o a computer????? JanRwl@A... 2003-01-03 21:34:18 UTC Re: [CAD_CAM_EDM_DRO] Re: Stepper control w/o a computer????? Dan Mauch 2003-01-04 07:45:34 UTC RE: [CAD_CAM_EDM_DRO] Re: Stepper control w/o a computer?????