Motor cable
Posted by
P. J. Hicks
on 2003-01-06 11:16:13 UTC
Hi,
I have my Sherline/Xylotex/Mach1 system up and running.....finally! The
cable I found and used for the leads to the motors from the driver is 4
conductor, foil shielded with a ground lead next to the shield. The problem
is that this cable is not very flexible.
Any suggestions for a more flexible cable and where to get it? I would like
to get enough and of a suitable size that I can use it on my BP size
mill/drill later on. I will probably use steppers on it also.
Thanks, PJH
I have my Sherline/Xylotex/Mach1 system up and running.....finally! The
cable I found and used for the leads to the motors from the driver is 4
conductor, foil shielded with a ground lead next to the shield. The problem
is that this cable is not very flexible.
Any suggestions for a more flexible cable and where to get it? I would like
to get enough and of a suitable size that I can use it on my BP size
mill/drill later on. I will probably use steppers on it also.
Thanks, PJH
Discussion Thread
P. J. Hicks
2003-01-06 11:16:13 UTC
Motor cable
JanRwl@A...
2003-01-06 18:00:49 UTC
Re: [CAD_CAM_EDM_DRO] Motor cable
Carol & Jerry Jankura
2003-01-06 20:13:48 UTC
RE: [CAD_CAM_EDM_DRO] Motor cable
CV Desper
2003-01-07 10:09:39 UTC
Re: [CAD_CAM_EDM_DRO] Motor cable
Randy Gordon-Gilmore
2003-01-07 10:29:19 UTC
Flexible cable and shielding
JanRwl@A...
2003-01-07 15:15:57 UTC
Re: [CAD_CAM_EDM_DRO] Flexible cable and shielding
Randy Gordon-Gilmore
2003-01-07 22:10:17 UTC
Re: Flexible cable and shielding
JanRwl@A...
2003-01-08 16:34:48 UTC
Re: [CAD_CAM_EDM_DRO] Re: Flexible cable and shielding
ccq@x...
2003-01-08 17:16:37 UTC
Re: [CAD_CAM_EDM_DRO] Re: Flexible cable and shielding