Re: Interface for CNCPro, etc.
Posted by
Jim Fackert
on 2000-02-21 18:34:32 UTC
I would prefer a DB-25 out the back to a separate opto-isolated breakout
board with a connectorized terminal strip... or optos in the pc plug-in
board, and DB-25 to a standard breakout board. (most of the DIN terminal
strip makers like Phoenix make DB-25 to terminal strip boards for reasonable
$$)
It is hard to beat the price of a generic parallel port interface card, so
the external buffer/ts board might make the most economic sense. Keeps the
fire out of the box too.
Add some diagnostic LED's while you are at it!
for what it's worth...
Jim Fackert
board with a connectorized terminal strip... or optos in the pc plug-in
board, and DB-25 to a standard breakout board. (most of the DIN terminal
strip makers like Phoenix make DB-25 to terminal strip boards for reasonable
$$)
It is hard to beat the price of a generic parallel port interface card, so
the external buffer/ts board might make the most economic sense. Keeps the
fire out of the box too.
Add some diagnostic LED's while you are at it!
for what it's worth...
Jim Fackert
----- Original Message -----
From: Harrison, Doug <dharrison@...>
> Suppose I design a card that will fit in one ISA or PCI slot that has
> optoisolation, 5V isolated supply for outputs and a screw terminal strip
> that sticks out the back for direct connection to amps, switches and aux
> I/O.
Discussion Thread
Harrison, Doug
2000-02-21 17:22:59 UTC
Interface for CNCPro, etc.
stratton@m...
2000-02-21 17:42:14 UTC
Re: Interface for CNCPro, etc.
Bertho Boman
2000-02-21 17:51:18 UTC
Re: Interface for CNCPro, etc.
Harrison, Doug
2000-02-21 18:19:49 UTC
RE: Interface for CNCPro, etc.
Harrison, Doug
2000-02-21 18:27:23 UTC
RE: Interface for CNCPro, etc.
Jim Fackert
2000-02-21 18:34:32 UTC
Re: Interface for CNCPro, etc.
Jim Fackert
2000-02-21 18:41:21 UTC
Re: Interface for CNCPro, etc.
stratton@m...
2000-02-21 19:02:46 UTC
Re: Interface for CNCPro, etc.
Brian Bartholomew
2000-02-21 20:36:17 UTC
Interface for CNCPro, etc.
Jim Fackert
2000-02-21 20:49:44 UTC
Re: Interface for CNCPro, etc.
Brian Pitt
2000-02-22 02:42:37 UTC
Re: Interface for CNCPro, etc.
Marshall Pharoah
2000-02-22 04:12:30 UTC
Re: Interface for CNCPro, etc.
Carlos Guillermo
2000-02-22 05:29:36 UTC
RE: Re: Interface for CNCPro, etc.
D.F.S.
2000-02-22 10:32:25 UTC
Re: Interface for CNCPro, etc.