RE: Re: Interface for CNCPro, etc.

Brian -

I ordered 4 of those motors. They look nice, but I missed the fine print
about them being brushless!
This model senses the rotor position from extra tracks on the encoder wheel,
instead of the hall sensor setup I'm familiar with. Can you point me to the
brushless motor control chips you mentioned, and maybe also an appnote
sample circuit?

Thanks,
Carlos Guillermo

> From: "Brian Pitt" <bfp@...>
>
> folowup on the
> Shinano Kenshi 24VDC Servo Motor with Encoder Res: 500 Pulses/Rotation
> ref digest #348 Message:10
> the encoder is 500 P/R for each channel or 2000 in quadrature
> plus index pulse,brushless motor control chips can be found
> for <$5 in onesies
>