CAD CAM EDM DRO - Yahoo Group Archive

Re: Interface for CNCPro, etc.

Posted by Jim Fackert
on 2000-02-21 20:49:44 UTC
> | we are rapidly approaching the day where a commodity PC costs less
> | than specialized I/O or interface boards. Perhaps the computer
> | should be considered expendable..

Sure, the motherboard is cheap... less than $100. Add the processor, memory,
and particularly labor in troubleshooting and re-configuring a new system,
and it's not so cheap. Costs more to install the programs and configure
than the basic hardware costs!

Jim

Discussion Thread

Harrison, Doug 2000-02-21 17:22:59 UTC Interface for CNCPro, etc. stratton@m... 2000-02-21 17:42:14 UTC Re: Interface for CNCPro, etc. Bertho Boman 2000-02-21 17:51:18 UTC Re: Interface for CNCPro, etc. Harrison, Doug 2000-02-21 18:19:49 UTC RE: Interface for CNCPro, etc. Harrison, Doug 2000-02-21 18:27:23 UTC RE: Interface for CNCPro, etc. Jim Fackert 2000-02-21 18:34:32 UTC Re: Interface for CNCPro, etc. Jim Fackert 2000-02-21 18:41:21 UTC Re: Interface for CNCPro, etc. stratton@m... 2000-02-21 19:02:46 UTC Re: Interface for CNCPro, etc. Brian Bartholomew 2000-02-21 20:36:17 UTC Interface for CNCPro, etc. Jim Fackert 2000-02-21 20:49:44 UTC Re: Interface for CNCPro, etc. Brian Pitt 2000-02-22 02:42:37 UTC Re: Interface for CNCPro, etc. Marshall Pharoah 2000-02-22 04:12:30 UTC Re: Interface for CNCPro, etc. Carlos Guillermo 2000-02-22 05:29:36 UTC RE: Re: Interface for CNCPro, etc. D.F.S. 2000-02-22 10:32:25 UTC Re: Interface for CNCPro, etc.