CAD CAM EDM DRO - Yahoo Group Archive

Re: Gecko 210's ouput switching Question

Posted by Alan Marconett KM6VV
on 2003-02-22 10:14:51 UTC
Hi Mariss,

Kinda hard to see the LEDs when they're all boxed up!

Alan KM6VV


"Mariss Freimanis " wrote:
>
> Andrew,
>
> Very simple. If the "power" LED is unlit, switch the motors. If ithe
> LED is lit, wait until it goes out before switching.
>
> Mariss

Discussion Thread

Andrew Mawson <andrew@m... 2003-02-21 13:30:24 UTC Gecko 210's ouput switching Question mayfieldtm <mayfiet@i... 2003-02-21 14:08:22 UTC Re: Gecko 210's ouput switching Question turbulatordude <davemucha@j... 2003-02-21 16:58:09 UTC Re: Gecko 210's ouput switching Question Mariss Freimanis <mariss92705@y... 2003-02-21 17:35:16 UTC Re: Gecko 210's ouput switching Question Alan Marconett KM6VV 2003-02-22 10:14:51 UTC Re: Gecko 210's ouput switching Question Andrew Mawson <andrew@m... 2003-02-22 10:58:32 UTC Re: Gecko 210's ouput switching Question turbulatordude <davemucha@j... 2003-02-22 12:07:22 UTC Re: Gecko 210's ouput switching Question Jon Elson 2003-02-22 21:44:39 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko 210's ouput switching Question JanRwl@A... 2003-02-22 23:05:47 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko 210's ouput switching Question Andrew Mawson <andrew@m... 2003-02-23 00:48:13 UTC Re: Gecko 210's ouput switching Question turbulatordude <davemucha@j... 2003-02-23 06:12:10 UTC Re: Gecko 210's ouput switching Question Jon Elson 2003-02-23 20:17:46 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko 210's ouput switching Question