CAD CAM EDM DRO - Yahoo Group Archive

Re: Gecko 210's ouput switching Question

on 2003-02-21 17:35:16 UTC
Andrew,

Very simple. If the "power" LED is unlit, switch the motors. If ithe
LED is lit, wait until it goes out before switching.

Mariss

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Andrew Mawson <andrew@m...>"
<andrew@m...> wrote:
> Hi,
>
> I'm planning to use a fourth Gecko 210 on my mill to drive a rotary
> axis, but only on a temporary 'as needed' bassis. I was about to
add
> a suitable 4 way socket for the stepper motor to be plugged into
when
> the need arises.
>
> But do Geckos object to the motors being unplugged, and if so what
is
> the best way of putting them in a safe state - do I need to
interlock
> the main power to the Gecko 210 ?
>
> TIA
>
> Andrew Mawson

Discussion Thread

Andrew Mawson <andrew@m... 2003-02-21 13:30:24 UTC Gecko 210's ouput switching Question mayfieldtm <mayfiet@i... 2003-02-21 14:08:22 UTC Re: Gecko 210's ouput switching Question turbulatordude <davemucha@j... 2003-02-21 16:58:09 UTC Re: Gecko 210's ouput switching Question Mariss Freimanis <mariss92705@y... 2003-02-21 17:35:16 UTC Re: Gecko 210's ouput switching Question Alan Marconett KM6VV 2003-02-22 10:14:51 UTC Re: Gecko 210's ouput switching Question Andrew Mawson <andrew@m... 2003-02-22 10:58:32 UTC Re: Gecko 210's ouput switching Question turbulatordude <davemucha@j... 2003-02-22 12:07:22 UTC Re: Gecko 210's ouput switching Question Jon Elson 2003-02-22 21:44:39 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko 210's ouput switching Question JanRwl@A... 2003-02-22 23:05:47 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko 210's ouput switching Question Andrew Mawson <andrew@m... 2003-02-23 00:48:13 UTC Re: Gecko 210's ouput switching Question turbulatordude <davemucha@j... 2003-02-23 06:12:10 UTC Re: Gecko 210's ouput switching Question Jon Elson 2003-02-23 20:17:46 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko 210's ouput switching Question