Re: Gecko 210's ouput switching Question
Posted by
Andrew Mawson <andrew@m...
on 2003-02-22 10:58:32 UTC
Alan,
Extactly my thoughts !
Need a more practical solution Mariss !!!!
Andrew
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Alan Marconett KM6VV
<KM6VV@a...> wrote:
Extactly my thoughts !
Need a more practical solution Mariss !!!!
Andrew
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Alan Marconett KM6VV
<KM6VV@a...> wrote:
> Hi Mariss,ithe
>
> Kinda hard to see the LEDs when they're all boxed up!
>
> Alan KM6VV
>
>
> "Mariss Freimanis " wrote:
> >
> > Andrew,
> >
> > Very simple. If the "power" LED is unlit, switch the motors. If
> > LED is lit, wait until it goes out before switching.
> >
> > Mariss
Discussion Thread
Andrew Mawson <andrew@m...
2003-02-21 13:30:24 UTC
Gecko 210's ouput switching Question
mayfieldtm <mayfiet@i...
2003-02-21 14:08:22 UTC
Re: Gecko 210's ouput switching Question
turbulatordude <davemucha@j...
2003-02-21 16:58:09 UTC
Re: Gecko 210's ouput switching Question
Mariss Freimanis <mariss92705@y...
2003-02-21 17:35:16 UTC
Re: Gecko 210's ouput switching Question
Alan Marconett KM6VV
2003-02-22 10:14:51 UTC
Re: Gecko 210's ouput switching Question
Andrew Mawson <andrew@m...
2003-02-22 10:58:32 UTC
Re: Gecko 210's ouput switching Question
turbulatordude <davemucha@j...
2003-02-22 12:07:22 UTC
Re: Gecko 210's ouput switching Question
Jon Elson
2003-02-22 21:44:39 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko 210's ouput switching Question
JanRwl@A...
2003-02-22 23:05:47 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko 210's ouput switching Question
Andrew Mawson <andrew@m...
2003-02-23 00:48:13 UTC
Re: Gecko 210's ouput switching Question
turbulatordude <davemucha@j...
2003-02-23 06:12:10 UTC
Re: Gecko 210's ouput switching Question
Jon Elson
2003-02-23 20:17:46 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko 210's ouput switching Question