CAD CAM EDM DRO - Yahoo Group Archive

Re: fickle y-axis

Posted by forumtvm
on 2003-03-17 20:48:40 UTC
Hi Mariss,

I am not as knowledgable about steppers as you, but with all due
respect, is not the sequence you described for a half stepping motor?
In fact, I am using a 200 steps motor and half-stepping, so that
would make it a 400 steps motor, that is, it should have 100 poles
per phase?

Regards

Peter

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Mariss Freimanis"
<mariss92705@y...> wrote:
> Peter,
>
> A 200 step per revolution motor is in fact a 50 pole motor. The
full-
> step sequence (00, 01, 11, 10) takes four full steps before it
> repeats. It repeats 50 times (for 50 poles) to make one revolution.
>
> Mariss
>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "forumtvm" <forumtvm@y...>
> wrote:
> > Hi,
> >
> > Just one small question. In a stepper motor with 100 poles for
> phase
> > A and 100 poles for phase B, when say phase A is activated, does
> all
> > the 100 poles get magnetised. I suspect this is the key I need to
> > grasp before I get to understand why my y-axis got to behave so
> > erratically when one wire got loose/disconnected.
> >
> > Peter

Discussion Thread

forumtvm 2003-03-15 05:10:25 UTC fickle y-axis forumtvm 2003-03-16 22:01:10 UTC Re: fickle y-axis jeffalanp 2003-03-17 00:29:25 UTC Re: fickle y-axis forumtvm 2003-03-17 01:58:02 UTC Re: fickle y-axis forumtvm 2003-03-17 10:32:45 UTC Re: fickle y-axis jeffalanp 2003-03-17 11:47:04 UTC Re: fickle y-axis forumtvm 2003-03-17 13:57:45 UTC Re: fickle y-axis forumtvm 2003-03-17 15:27:16 UTC Re: fickle y-axis jeffalanp 2003-03-17 15:32:28 UTC Re: fickle y-axis Mariss Freimanis 2003-03-17 15:58:03 UTC Re: fickle y-axis jeffalanp 2003-03-17 15:59:45 UTC Re: fickle y-axis forumtvm 2003-03-17 20:48:40 UTC Re: fickle y-axis forumtvm 2003-03-17 21:06:36 UTC Re: fickle y-axis Mariss Freimanis 2003-03-17 21:47:41 UTC Re: fickle y-axis Mariss Freimanis 2003-03-17 22:01:38 UTC Re: fickle y-axis jeffalanp 2003-03-18 09:47:31 UTC Re: fickle y-axis forumtvm 2003-03-18 11:44:09 UTC Re: fickle y-axis jeffalanp 2003-03-18 12:19:14 UTC Re: fickle y-axis forumtvm 2003-03-18 12:53:08 UTC Re: fickle y-axis