Re: Problem

Hi, you are reading the pin numbers for the IDC26 connector. Those
pins are not used in the software setup. The software refers to the
DB25 pin numbers. The DB25 pins 6 and 7 are for Z step and dir.
Dean

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "mmurray70" <mmurray70@n...>
wrote:

> I was just setting up TurboCNC to use with my Xylotex board and the
> board calls for sterp/dir pins 11 and 13 for the Z axis but TurboCNC
> will not allow me to use these pins. What should i do to fix this?
> Does it have something to do with port type? What type should it be
> on? Please help me out. Thanks.