Re: Problem - Xylotex connections
Posted by
turbulatordude
on 2003-03-22 03:59:20 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "mmurray70" <mmurray70@n...>
wrote:
DB25 IDC26 Usage
------------ --------- -------
Pin 2 3 Step X
Pin 3 5 Dir X
Pin 4 7 Step Y
Pin 5 9 Dir Y
Pin 6 11 Step Z
Pin 7 13 Dir Z
It's simple, the PARALLEL port connections should be pins 6 and 7 and
those go to the Xylotex board connections 11 and 13.
In Turbo CNC you assign pin 7 as dir and pin 6 as step.
Are you using the newer version 3.24 ?
Dave
wrote:
> I was just setting up TurboCNC to use with my Xylotex board and theTurboCNC
> board calls for sterp/dir pins 11 and 13 for the Z axis but
> will not allow me to use these pins. What should i do to fix this?The drive uses the following signals:
> Does it have something to do with port type? What type should it be
> on? Please help me out. Thanks.
DB25 IDC26 Usage
------------ --------- -------
Pin 2 3 Step X
Pin 3 5 Dir X
Pin 4 7 Step Y
Pin 5 9 Dir Y
Pin 6 11 Step Z
Pin 7 13 Dir Z
It's simple, the PARALLEL port connections should be pins 6 and 7 and
those go to the Xylotex board connections 11 and 13.
In Turbo CNC you assign pin 7 as dir and pin 6 as step.
Are you using the newer version 3.24 ?
Dave
Discussion Thread
mmurray70
2003-03-21 18:48:57 UTC
Problem
deanc500
2003-03-21 19:02:45 UTC
Re: Problem
Mike
2003-03-21 20:16:19 UTC
Motor Sizing for a Small Vertical Mill Spindle
Andrew Mawson
2003-03-22 00:39:37 UTC
Re: Problem
turbulatordude
2003-03-22 03:59:20 UTC
Re: Problem - Xylotex connections
mmurray70
2003-03-22 06:37:58 UTC
Re: Problem