Problem

on 2003-03-21 18:48:57 UTC

I was just setting up TurboCNC to use with my Xylotex board and the
board calls for sterp/dir pins 11 and 13 for the Z axis but TurboCNC
will not allow me to use these pins. What should i do to fix this?
Does it have something to do with port type? What type should it be
on? Please help me out. Thanks.

Discussion Thread

mmurray70 2003-03-21 18:48:57 UTC Problem deanc500 2003-03-21 19:02:45 UTC Re: Problem Mike 2003-03-21 20:16:19 UTC Motor Sizing for a Small Vertical Mill Spindle Andrew Mawson 2003-03-22 00:39:37 UTC Re: Problem turbulatordude 2003-03-22 03:59:20 UTC Re: Problem - Xylotex connections mmurray70 2003-03-22 06:37:58 UTC Re: Problem