Re: Problem
Posted by
Andrew Mawson
on 2003-03-22 00:39:37 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "mmurray70" <mmurray70@n...>
wrote:
status input only - see the following url which you will have
to 'unsplit'
http://www.google.co.uk/search?
q=cache:D_4b2bSCvbwC:www.doc.ic.ac.uk/~ih/doc/par/+%22parallel+port%
22+interfacing&hl=en&ie=UTF-8
Andrew Mawson
Bromley,
Kent,
UK
wrote:
> I was just setting up TurboCNC to use with my Xylotex board and theTurboCNC
> board calls for sterp/dir pins 11 and 13 for the Z axis but
> will not allow me to use these pins. What should i do to fix this?By my understanding pins 11 & 13 on an original parallel port were
> Does it have something to do with port type? What type should it be
> on? Please help me out. Thanks.
status input only - see the following url which you will have
to 'unsplit'
http://www.google.co.uk/search?
q=cache:D_4b2bSCvbwC:www.doc.ic.ac.uk/~ih/doc/par/+%22parallel+port%
22+interfacing&hl=en&ie=UTF-8
Andrew Mawson
Bromley,
Kent,
UK
Discussion Thread
mmurray70
2003-03-21 18:48:57 UTC
Problem
deanc500
2003-03-21 19:02:45 UTC
Re: Problem
Mike
2003-03-21 20:16:19 UTC
Motor Sizing for a Small Vertical Mill Spindle
Andrew Mawson
2003-03-22 00:39:37 UTC
Re: Problem
turbulatordude
2003-03-22 03:59:20 UTC
Re: Problem - Xylotex connections
mmurray70
2003-03-22 06:37:58 UTC
Re: Problem