CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Need DOS TCP/IP connection solution.

Posted by Bob Simon
on 2003-03-28 10:16:19 UTC
At 16:03 3/28/2003 +0000, you wrote:
>Hi all
>
>Sorry, this may be fractionally OT, but I know this is the fount of all
>knowledge in the universe ...
>
>Sneakernetting floppies from my Mac to a DOS only PC CNC system is driving
>me nuts, does anyone have a network solution for DOS - preferably TCP/IP or
>something useful like SMB? FTPing files is perfectly OK.

Look in the files section of the group at;

http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/

"MSclient for DOS machine tools" describes a DOS networking solution that's
free from Microsoft.

The file outlines setting up networking with the NetBEUI protocol, however
a little fidgeting with packet drivers and you could enable TCP/IP
communications as well. Good Luck!

-Bob

Discussion Thread

Neil Gillies 2003-03-28 08:03:11 UTC Need DOS TCP/IP connection solution. alex 2003-03-28 08:13:58 UTC Re: [CAD_CAM_EDM_DRO] Need DOS TCP/IP connection solution. sparkness2001 2003-03-28 08:55:00 UTC Re: Need DOS TCP/IP connection solution. Bob Simon 2003-03-28 10:16:19 UTC Re: [CAD_CAM_EDM_DRO] Need DOS TCP/IP connection solution. James Wilsom 2003-03-28 11:00:40 UTC Re: [CAD_CAM_EDM_DRO] Re: Need DOS TCP/IP connection solution. Tom Murray 2003-03-28 12:26:38 UTC Re: Need DOS TCP/IP connection solution. Dave Dillabough 2003-03-28 15:03:30 UTC Re: [CAD_CAM_EDM_DRO] Need DOS TCP/IP connection solution. aerowright 2003-03-28 20:41:46 UTC Re: Need DOS TCP/IP connection solution. Neil Gillies 2003-03-30 13:09:38 UTC Re: Need DOS TCP/IP connection solution.