CAD CAM EDM DRO - Yahoo Group Archive

Re: Need DOS TCP/IP connection solution.

Posted by Tom Murray
on 2003-03-28 12:26:38 UTC
>The file outlines setting up networking with the NetBEUI protocol,
>however a little fidgeting with packet drivers and you could enable
>TCP/IP communications as well. Good Luck!

Microsoft Client for DOS allows for TCP/IP communications and it is
very easy to set it up.

I recommend the following site to learn more about networking with
DOS:

www.wown.com

Great site! I don't think I could have done it without this useful
resource.

-Tom Murray

Discussion Thread

Neil Gillies 2003-03-28 08:03:11 UTC Need DOS TCP/IP connection solution. alex 2003-03-28 08:13:58 UTC Re: [CAD_CAM_EDM_DRO] Need DOS TCP/IP connection solution. sparkness2001 2003-03-28 08:55:00 UTC Re: Need DOS TCP/IP connection solution. Bob Simon 2003-03-28 10:16:19 UTC Re: [CAD_CAM_EDM_DRO] Need DOS TCP/IP connection solution. James Wilsom 2003-03-28 11:00:40 UTC Re: [CAD_CAM_EDM_DRO] Re: Need DOS TCP/IP connection solution. Tom Murray 2003-03-28 12:26:38 UTC Re: Need DOS TCP/IP connection solution. Dave Dillabough 2003-03-28 15:03:30 UTC Re: [CAD_CAM_EDM_DRO] Need DOS TCP/IP connection solution. aerowright 2003-03-28 20:41:46 UTC Re: Need DOS TCP/IP connection solution. Neil Gillies 2003-03-30 13:09:38 UTC Re: Need DOS TCP/IP connection solution.