Re: [CAD_CAM_EDM_DRO] Re: Vinyl cutting knife in place of router

Check this guy out.

http://www.carlsondesign.com/

He has the plotter cutter thing down. Lots of good ideas here.

Mark

zeff1015@... wrote:

> The swivel setup you spoke of is called a drag knife, because the blade is
> turned in the proper direction when pulled by the machine. This setup would
> not provide the cleanest cuts in the thick matte material, it is much better
> for cutting vinyl (2 to 3 mil). It might work, but I would find someone that
> has used the setup on the material before you shell out the money to setup
> your own.
>