Re: [CAD_CAM_EDM_DRO] Tuning steppers
Posted by
Ken Lowther
on 2000-03-13 04:32:10 UTC
Joel Jacobs wrote:
People running it under Windows report problems like this for some
reason. The problem dissappears for them when they boot to a DOS
prompt. I don't know the software involved so I don't know if this is
possible in your case.
--
Ken Lowther
Youngstown, Ohio
http://www.atmsite.org
ATM FAQ and more
Good starting place for amateur telescope makers
>The astronomy software I mentioned in an earlier post is DOS based.
> From: "Joel Jacobs" <jj@...>
>
>
> freqmot from 20 to 100 just to get the GUI working and that may be the
> problem but how much computer does it take to run a stepper motor? I see
>
People running it under Windows report problems like this for some
reason. The problem dissappears for them when they boot to a DOS
prompt. I don't know the software involved so I don't know if this is
possible in your case.
--
Ken Lowther
Youngstown, Ohio
http://www.atmsite.org
ATM FAQ and more
Good starting place for amateur telescope makers
Discussion Thread
Stephen Tate
2000-03-12 10:21:37 UTC
Tuning steppers
Tim Goldstein
2000-03-12 12:13:14 UTC
RE: [CAD_CAM_EDM_DRO] Tuning steppers
Darrell
2000-03-12 22:56:39 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers
Joel Jacobs
2000-03-12 23:23:17 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers
Ken Lowther
2000-03-13 04:32:10 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers
Tim Goldstein
2000-03-13 07:00:12 UTC
RE: [CAD_CAM_EDM_DRO] Tuning steppers
Darrell
2000-03-13 12:12:23 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers
Matt Shaver
2000-03-13 14:15:35 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers
Darrell
2000-03-13 17:01:00 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers
Matt Shaver
2000-03-13 19:24:56 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers
Darrell
2000-03-13 21:08:37 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers
Matt Shaver
2000-03-14 08:58:29 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers
Joel Jacobs
2000-03-14 09:47:29 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers