Re: [CAD_CAM_EDM_DRO] Tuning steppers
Posted by
Joel Jacobs
on 2000-03-14 09:47:29 UTC
----- Original Message -----
From: "Matt Shaver" <mshaver@...>
> 2. Would it be useful if you could specify (in a .ini parameter) the
normal
> (resting) state of the step signals?
>
> Matt
Specifying whether the direction signal is valid on the rising or falling
edge of the step signal would be nice. Even to confirm the default would be
nice. My controller steps on the rising edge of the step signal.
Joel
Discussion Thread
Stephen Tate
2000-03-12 10:21:37 UTC
Tuning steppers
Tim Goldstein
2000-03-12 12:13:14 UTC
RE: [CAD_CAM_EDM_DRO] Tuning steppers
Darrell
2000-03-12 22:56:39 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers
Joel Jacobs
2000-03-12 23:23:17 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers
Ken Lowther
2000-03-13 04:32:10 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers
Tim Goldstein
2000-03-13 07:00:12 UTC
RE: [CAD_CAM_EDM_DRO] Tuning steppers
Darrell
2000-03-13 12:12:23 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers
Matt Shaver
2000-03-13 14:15:35 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers
Darrell
2000-03-13 17:01:00 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers
Matt Shaver
2000-03-13 19:24:56 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers
Darrell
2000-03-13 21:08:37 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers
Matt Shaver
2000-03-14 08:58:29 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers
Joel Jacobs
2000-03-14 09:47:29 UTC
Re: [CAD_CAM_EDM_DRO] Tuning steppers