Re: [CAD_CAM_EDM_DRO] Tuning steppers

> From: "Darrell" <dgehlsen@...>
>
> Matt,
> Looking at the step signals, using freqmot, I see the step line toggling
> between high and low while outputting step signals. What is going on? If I
> put it in jog mode of .01 and jog it I get a normally high with pulses

going

> low then the next set show normally low with pulses going high.

I don't know, I'll have to ask Fred about this tomorrow. I haven't scoped the
output in a long time, but it must not have mattered on the last machine I
built since it runs OK. I'll find out and get back to you tomorrow. A couple
of questions:

1. Are you running the 29-feb-2000 version?

2. Would it be useful if you could specify (in a .ini parameter) the normal
(resting) state of the step signals?

Matt