Re: FAILLING MEMORY ON MY CNC LATHE
Posted by
doug98105
on 2003-09-16 09:13:41 UTC
A couple times when I've had memory problems with my CNC machines
it's because the on-board rechargeable battery was going bad.
Replace battery and problems went away.
Doug
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "jeff_birt2000"
<birt_j@e...> wrote:
it's because the on-board rechargeable battery was going bad.
Replace battery and problems went away.
Doug
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "jeff_birt2000"
<birt_j@e...> wrote:
> I havn't watched this whole thread so I hope I'm not repeatingoxidize
> someting. It may be possible that you EPROM chips just need to be
> reseated (pulled out and then plugged back in). The pins can
> and cause random problems. Same thing goes with any connectors on
> the board. Try reseating everything.
>
> Jeff
>
>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "mrdavidpontes"
> <mrdavidpontes@a...> wrote:
> > Hi,
> > Thanks for reply. My DYNA 3000 has checkup for the RAM ,but
> only
> > list nunber of bytes on board, same for the eprom. david pontes
> >
> > --- In CAD_CAM_EDM_DRO@yahoogroups.com, Alan Marconett KM6VV
> > <KM6VV@a...> wrote:
> > > Hi David,
Discussion Thread
mrdavidpontes
2003-09-14 21:39:29 UTC
FAILLING MEMORY ON MY CNC LATHE
Torsten
2003-09-15 02:15:05 UTC
Re: FAILLING MEMORY ON MY CNC LATHE
Vince Negrete
2003-09-15 02:53:51 UTC
Re: [CAD_CAM_EDM_DRO] FAILLING MEMORY ON MY CNC LATHE
Vince Negrete
2003-09-15 03:04:12 UTC
Re: [CAD_CAM_EDM_DRO] FAILLING MEMORY ON MY CNC LATHE
Jon Elson
2003-09-15 09:34:44 UTC
Re: [CAD_CAM_EDM_DRO] FAILLING MEMORY ON MY CNC LATHE
Alan Marconett KM6VV
2003-09-15 10:21:16 UTC
Re: [CAD_CAM_EDM_DRO] FAILLING MEMORY ON MY CNC LATHE
mrdavidpontes
2003-09-16 01:33:33 UTC
Re: FAILLING MEMORY ON MY CNC LATHE
jeff_birt2000
2003-09-16 08:00:55 UTC
Re: FAILLING MEMORY ON MY CNC LATHE
doug98105
2003-09-16 09:13:41 UTC
Re: FAILLING MEMORY ON MY CNC LATHE
tomp_tag
2003-09-17 00:16:04 UTC
Re: [CAD_CAM_EDM_DRO] Re: FAILLING MEMORY ON MY CNC LATHE