Re: [CAD_CAM_EDM_DRO] Are these motors usefull for a Bridgeport?

Jon, Eric's original idea that there is a encoder and tach
output surely seems to be correct. I made a mistake and
assumed that there was only 5 wires, and there really is
seven, as you stated in your original post. I must have
mis read your original post (oops). Most of the encoders
I have come across have small plastic covers that can
be removed to expose the wheel and electronics. Just
make sure you connect power to the right wires.

Steve

----------
From: Jon Anderson <janders@...>
To: CAD_CAM_EDM_DRO@onelist.com
Subject: Re: [CAD_CAM_EDM_DRO] Are these motors usefull for a Bridgeport?
Date: Friday, March 24, 2000 9:15 AM

From: Jon Anderson <janders@...>

Steve Carlisle wrote:

> Jon, so does this mean the encoder gets it's power through
> the tach wires?

Well, I'm hardly an expert here, but there's also pins labeled
Common, +12v, and Ground, so I'd think that's what is supplying
the encoder. Heck, maybe I'll try opening it up and seeing what's
inside!

Jon

------------------------------------------------------------------------
GET A NEXTCARD VISA, in 30 seconds! Get rates
as low as 0.0% Intro APR and no hidden fees.
Apply NOW!
http://click.egroups.com/1/975/2/_/423600/_/953918240/
------------------------------------------------------------------------

Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
To Unsubscribe, read archives, change to or from digest.
Go to: http://www.onelist.com/isregistered.cgi
Log on, and you will go to Member Center, and you can make changes there.
For the FAQ, go to http://www.ktmarketing.com/faq.html
bill,
List Manager