RE: [CAD_CAM_EDM_DRO] Re: servo board

Huge difference between a true closed look servo with a STG board or
Jon's setup compared to an open loop implementation using a G320/G340.
Don't get me wrong, I use G320's myself and love them. Just don't think
that they are the same as a system where the servo loop is controlled by
the computer.

Tim
[Denver, CO]
Visual Mill 5.0 Basic at a price too low to post!

Sherline & Taig products at Deep Discount
Mach1 & DeskCNC with credit card ordering
www.KTMarketing.com/Sherline
Timg@...

> -----Original Message-----
>
>
> If you look at iicosystems site then you will notice that he is
> showing a schematic how to connect a board from the other website you
> have mentioned...
>
> However, $800 for a servo? I see no point of spending that much when
> you can get a Gecko for less. I would say that if the ISA servo
> controller guy were smart he would drop his price to $400 and that
> would put Gecko next day in receivership...
> gecko costs around $150 per axis.
> Oh, another thing, if you have to have more than 3 axis than it is a
> different calculation.
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html