RE: [CAD_CAM_EDM_DRO] Re: servo board

. > It would be well worth investing some time into learning about the
. > different servo setups and what they are all about before giving out advise on them.

This wasn’t attempted to be an advice, as I mentioned in the beginning of my message I’m NOT an servo expert! It was mentioned as an opening for discussion!

That’s what a forum is about ?
Sorry about my bad English.

Regards,
Eze

> > -----Original Message-----
> > Hi,
> >
> > As I mentioned earlier I'm NOT an expert on servos or servo
> > drivers BUT, Isn't it quite simple to setup the Gecko to
> > communicate with the computer to, if you so desire? I don't
> > know if its vise or not, but it's possible, I have seen it
> > somewhere on the net.
> >
> > Regards,
> > Eze
>
>
> Just feeding the encoder position from a Gecko to the computer only
> works if the program you are using accepts encoder feedback in a step
> and direction output mode. EMC does it with an encoder board that is no
> longer available. I am not aware of any others that handle it. Even so,
> you will not achieve the performance that you can get with a true
> software controlled servo loop. For many purposes the Gecko with an
> open
> loop step and direction control program will give tremendous
> performance
> for the money. But, they are different animals. It would be well worth
> investing some time into learning about the different servo setups and
> what they are all about before giving out advise on them.
>
> Tim
> [Denver, CO]
> Visual Mill 5.0 Basic at a price too low to post!
>
> Sherline & Taig products at Deep Discount
> Mach1 & DeskCNC with credit card ordering
> www.KTMarketing.com/Sherline
> Timg@...
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...,
> timg@...
> Moderator: pentam@... indigo_red@... [Moderators]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
> aol://5863:126/rec.crafts.metalworking or go thru Google.com to
> reach it if
> you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this to be a
> sister site to the CCED group, as many of the same members are
> there, for
> OT subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
> DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to
> http://docs.yahoo.com/info/terms/
>
>

..............................................................
Lähetä oikeat joulukortit omalla kuvallasi! Maikkarin netissä.
http://www.mtv3.fi/postikortit/