Re: [CAD_CAM_EDM_DRO] Re: Controllers

>
>Yes, with Mach2 will support four axis on one parallel port. The four
>outputs are selected by using M codes. Trying to multiplex them may be a
>little tricky.
>
>Remember, the forth output port is currently used with the charge pump
>function if the charge pump function is selected. A solid-state relay can be
>connected to the same port and will be active anytime the charge pump is
>active.

Does this mean the fourth channel on these breakout boards cannot be used
to control a rotatry table (provides only ON-OFF control) ?

Mike