Re: [CAD_CAM_EDM_DRO] need information

It's extremely difficult to be able to satisfy ALL stepper motors feeding
habits. However, if you make your board to supply the correct stepping
pulses, at the correct voltage/current levels, and allow for 4,5,6, or
8-wire motors, you should be able to run 'most any motor. But this will be
a rather cumbersome task, and you'd be better off to rather, limit your
choice of motors to some common standard, then design a really efficient
driver board for that set of parameters. Hope this helps.

RayHex

----------

> From: Ali Faraz <alifaraze@...>
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Subject: [CAD_CAM_EDM_DRO] need information
> Date: Saturday, March 27, 2004 11:57 AM
>
> hi,
> i am new in cnc. please tell me if i make a driver board will it
> support all stepper motors regardless of company made?
>
> thanks
>
> alifaraz