CAD CAM EDM DRO - Yahoo Group Archive

Re: need information

Posted by caudlet
on 2004-03-28 10:50:19 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "ballendo" <ballendo@y...>
wrote:
> >In CAD_CAM_EDM_DRO, Jon Elson <elson@p...> wrote:
> > 5 wire motors require a rather special version of drive.
>
> Huh?
>
> 5 wire motors run happily on unipolar drives. They're just a six
wire
> motor with the center taps tied together.
>
> Ballendo

I think he means 5 phase motors. Can be 6 wires for unipolar up to
10 wires for bipolar.

Discussion Thread

Ali Faraz 2004-03-27 12:04:01 UTC need information Raymond Heckert 2004-03-27 19:50:49 UTC Re: [CAD_CAM_EDM_DRO] need information Jon Elson 2004-03-27 22:47:39 UTC Re: [CAD_CAM_EDM_DRO] need information ballendo 2004-03-28 07:24:52 UTC Re: need information caudlet 2004-03-28 10:50:19 UTC Re: need information ballendo 2004-03-28 11:43:32 UTC Re: need information Tony Jeffree 2004-03-28 13:39:20 UTC Re: [CAD_CAM_EDM_DRO] Re: need information Jon Elson 2004-03-28 23:14:02 UTC Re: [CAD_CAM_EDM_DRO] Re: need information Jon Elson 2004-03-28 23:21:58 UTC Re: [CAD_CAM_EDM_DRO] Re: need information