Re: [CAD_CAM_EDM_DRO] Re: need information
Posted by
Tony Jeffree
on 2004-03-28 13:39:20 UTC
At 19:58 28/03/2004, you wrote:
Not always. Sometimes, 5-wire motors are 5-phase motors with the 5 phases
wired in a ring. See:
http://www.cs.uiowa.edu/~jones/step/types.html
But with an Ohm meter it is easy to tell the difference.
Regards,
Tony
>Hello Thom,Ballendo -
>
>I don't think so. Here's more of the reply:
>
> >5 wire motors require a rather special version of drive.
> >
> >But, there are also 3 and 5 phase motors, that all require their own
> >type of drive, that is totally incompatible with the more common
> >2-phase motors.
> >Jon
>
>Since he mentioned 5 phase separately, I thought it might be useful
>to let folks know that 5 wire motors are just unipolar 6 wire motors
>with the commons connected...
>
>Ballendo
Not always. Sometimes, 5-wire motors are 5-phase motors with the 5 phases
wired in a ring. See:
http://www.cs.uiowa.edu/~jones/step/types.html
But with an Ohm meter it is easy to tell the difference.
Regards,
Tony
Discussion Thread
Ali Faraz
2004-03-27 12:04:01 UTC
need information
Raymond Heckert
2004-03-27 19:50:49 UTC
Re: [CAD_CAM_EDM_DRO] need information
Jon Elson
2004-03-27 22:47:39 UTC
Re: [CAD_CAM_EDM_DRO] need information
ballendo
2004-03-28 07:24:52 UTC
Re: need information
caudlet
2004-03-28 10:50:19 UTC
Re: need information
ballendo
2004-03-28 11:43:32 UTC
Re: need information
Tony Jeffree
2004-03-28 13:39:20 UTC
Re: [CAD_CAM_EDM_DRO] Re: need information
Jon Elson
2004-03-28 23:14:02 UTC
Re: [CAD_CAM_EDM_DRO] Re: need information
Jon Elson
2004-03-28 23:21:58 UTC
Re: [CAD_CAM_EDM_DRO] Re: need information