Re: [CAD_CAM_EDM_DRO] Re: need information
Posted by
Jon Elson
on 2004-03-28 23:14:02 UTC
ballendo wrote:
type drives handle this fine. The older R/L drives needed separate
resistors for each phase. Any drive where the center taps of six wire
motors are connected to the same terminal would handle the 5-wire
motor as well.
Jon
>>In CAD_CAM_EDM_DRO, Jon Elson <elson@p...> wrote:That depends on whose unipolar drive. Yes, some of the unipolar chopping
>>5 wire motors require a rather special version of drive.
>>
>>
>
>Huh?
>
>5 wire motors run happily on unipolar drives. They're just a six wire
>motor with the center taps tied together.
>
>
type drives handle this fine. The older R/L drives needed separate
resistors for each phase. Any drive where the center taps of six wire
motors are connected to the same terminal would handle the 5-wire
motor as well.
Jon
Discussion Thread
Ali Faraz
2004-03-27 12:04:01 UTC
need information
Raymond Heckert
2004-03-27 19:50:49 UTC
Re: [CAD_CAM_EDM_DRO] need information
Jon Elson
2004-03-27 22:47:39 UTC
Re: [CAD_CAM_EDM_DRO] need information
ballendo
2004-03-28 07:24:52 UTC
Re: need information
caudlet
2004-03-28 10:50:19 UTC
Re: need information
ballendo
2004-03-28 11:43:32 UTC
Re: need information
Tony Jeffree
2004-03-28 13:39:20 UTC
Re: [CAD_CAM_EDM_DRO] Re: need information
Jon Elson
2004-03-28 23:14:02 UTC
Re: [CAD_CAM_EDM_DRO] Re: need information
Jon Elson
2004-03-28 23:21:58 UTC
Re: [CAD_CAM_EDM_DRO] Re: need information