Re: need information
Posted by
ballendo
on 2004-03-28 07:24:52 UTC
>In CAD_CAM_EDM_DRO, Jon Elson <elson@p...> wrote:Huh?
> 5 wire motors require a rather special version of drive.
5 wire motors run happily on unipolar drives. They're just a six wire
motor with the center taps tied together.
Ballendo
Discussion Thread
Ali Faraz
2004-03-27 12:04:01 UTC
need information
Raymond Heckert
2004-03-27 19:50:49 UTC
Re: [CAD_CAM_EDM_DRO] need information
Jon Elson
2004-03-27 22:47:39 UTC
Re: [CAD_CAM_EDM_DRO] need information
ballendo
2004-03-28 07:24:52 UTC
Re: need information
caudlet
2004-03-28 10:50:19 UTC
Re: need information
ballendo
2004-03-28 11:43:32 UTC
Re: need information
Tony Jeffree
2004-03-28 13:39:20 UTC
Re: [CAD_CAM_EDM_DRO] Re: need information
Jon Elson
2004-03-28 23:14:02 UTC
Re: [CAD_CAM_EDM_DRO] Re: need information
Jon Elson
2004-03-28 23:21:58 UTC
Re: [CAD_CAM_EDM_DRO] Re: need information