Re: [CAD_CAM_EDM_DRO] Thanks - Servo Motor Make Up -w- Follow Up Question
Posted by
Jon Elson
on 2004-06-14 22:41:43 UTC
John Delaney wrote:
might get hot, but will be safe. If the cont. stall torque rating is
exceeded
for more than a minute or two on a small motor, it will go up in smoke,
and may take the driver with it.
Jon
>All who replied. Thanks very much. I'm just trying to patch up holesYup, that is exactly the idea.
>in my knowledge. That was very helpful.
>
>BTW - I've got my motors, older Reliance Micro 100 series, brushed. E-
>Bay buy. HP or HP like 500 CPM quadrature optical encoders.
>
>Follow up question:
>
>So assuming the servo system is set up and working correctly. If I
>were to tell software to keep the motor at some position 'A' and I
>placed a constant load on the motor to try to move from 'A' the
>result would be a series of pulses coming from the drive to the motor
>of sufficient amplitude to keep the motor at position 'A'. Yes? I
>imagine it would bounce within the limits of the encoder too?
>
>
>Then the motor is eventually going to get pretty hot if the load isIf the load is less than the continuous stall torque rating of the motor, it
>great enough?
>
>
might get hot, but will be safe. If the cont. stall torque rating is
exceeded
for more than a minute or two on a small motor, it will go up in smoke,
and may take the driver with it.
Jon
Discussion Thread
John Delaney
2004-06-13 15:55:32 UTC
Servo Motor Make Up?
Leslie Watts
2004-06-13 16:35:03 UTC
RE: [CAD_CAM_EDM_DRO] Servo Motor Make Up?
afogassa
2004-06-13 16:56:41 UTC
Re: Servo Motor Make Up?
tommy clay
2004-06-13 17:21:42 UTC
Re: [CAD_CAM_EDM_DRO] Servo Motor Make Up?
Gregory Kamysz
2004-06-13 19:22:16 UTC
Re: [CAD_CAM_EDM_DRO] Re: Servo Motor Make Up?
Jon Elson
2004-06-13 22:39:41 UTC
Re: [CAD_CAM_EDM_DRO] Servo Motor Make Up?
John Delaney
2004-06-14 11:58:31 UTC
Thanks - Servo Motor Make Up -w- Follow Up Question
vavaroutsos
2004-06-14 12:27:43 UTC
Re: Thanks - Servo Motor Make Up -w- Follow Up Question
Andy Wander
2004-06-14 12:34:07 UTC
RE: [CAD_CAM_EDM_DRO] Re: Thanks - Servo Motor Make Up -w- Follow Up Question
Fred Smith
2004-06-14 13:35:29 UTC
Re: Thanks - Servo Motor Make Up -w- Follow Up Question
Jon Elson
2004-06-14 22:41:43 UTC
Re: [CAD_CAM_EDM_DRO] Thanks - Servo Motor Make Up -w- Follow Up Question