CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: stepper to servo transition

Posted by Les Newell
on 2004-11-16 01:04:09 UTC
Hi Bruce,

I have used R991H boards and they work well. It looks like the TQ10 uses
hall sensors so motors that work with this drive should also work with
the Rutex drive.

> re:slip rings--

Why didn't I think of that? it is so obvious when you stop and think
about it :-)

Good luck with your project.

Les




Bruce Shapiro wrote:
>
>
> Thanks for the "heads up" on mixing drives and motors. It looks
> like Rutex makes a drive for hall-commutated motors:
>
> http://www.rutex.com/us/cart.php?
> target=product&action=view&product_id=16&category_id=5

Discussion Thread

Graham Stabler 2004-11-10 05:26:42 UTC Anyone using JR-Kerr? Steven Ciciora 2004-11-10 06:11:17 UTC Re: [CAD_CAM_EDM_DRO] Anyone using JR-Kerr? Dan Mauch 2004-11-10 06:23:24 UTC Re: [CAD_CAM_EDM_DRO] Anyone using JR-Kerr? Graham Stabler 2004-11-10 09:47:05 UTC Re: Anyone using JR-Kerr? Fred Smith 2004-11-10 12:41:34 UTC Re: Anyone using JR-Kerr? Graham Stabler 2004-11-11 02:58:23 UTC Re: Anyone using JR-Kerr? rudy905@y... 2004-11-11 17:57:53 UTC Re: Anyone using JR-Kerr? Fred Smith 2004-11-13 12:28:42 UTC Tuning DeskCNC servo drives, was Re: Anyone using JR-Kerr? taomc57 2004-11-13 13:58:39 UTC stepper to servo transition Les Newell 2004-11-13 15:04:41 UTC Re: [CAD_CAM_EDM_DRO] stepper to servo transition Graham Stabler 2004-11-13 17:36:12 UTC Re: stepper to servo transition Bruce Shapiro 2004-11-15 10:53:48 UTC Re: stepper to servo transition Les Newell 2004-11-15 12:02:56 UTC Re: [CAD_CAM_EDM_DRO] Re: stepper to servo transition Bruce Shapiro 2004-11-15 16:43:20 UTC Re: stepper to servo transition Les Newell 2004-11-16 01:04:09 UTC Re: [CAD_CAM_EDM_DRO] Re: stepper to servo transition