Re: Anyone using JR-Kerr?
Posted by
rudy905@y...
on 2004-11-11 17:57:53 UTC
You might take a look at the controller I made and have been selling
for about a year now, the Gamatronix Gamoto. It's a PID servo motor
controller, with a 3-Amp h-bridge. Commands are via serial, I2C, or
Cricket Bus.
Randy
www.gamatronix.com
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Graham Stabler" <eexgs@n...>
wrote:
for about a year now, the Gamatronix Gamoto. It's a PID servo motor
controller, with a 3-Amp h-bridge. Commands are via serial, I2C, or
Cricket Bus.
Randy
www.gamatronix.com
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Graham Stabler" <eexgs@n...>
wrote:
>
> I have been looking for cheapish command based motion control for a
> project I am working on in the department. I was looking at the 3-
> axis brush/brushless servo drives by JR-Kerr and noticed they can
> also be driven with step and direction which interesting for home
> use. Just wondered if anyone is using these?
>
> Graham
Discussion Thread
Graham Stabler
2004-11-10 05:26:42 UTC
Anyone using JR-Kerr?
Steven Ciciora
2004-11-10 06:11:17 UTC
Re: [CAD_CAM_EDM_DRO] Anyone using JR-Kerr?
Dan Mauch
2004-11-10 06:23:24 UTC
Re: [CAD_CAM_EDM_DRO] Anyone using JR-Kerr?
Graham Stabler
2004-11-10 09:47:05 UTC
Re: Anyone using JR-Kerr?
Fred Smith
2004-11-10 12:41:34 UTC
Re: Anyone using JR-Kerr?
Graham Stabler
2004-11-11 02:58:23 UTC
Re: Anyone using JR-Kerr?
rudy905@y...
2004-11-11 17:57:53 UTC
Re: Anyone using JR-Kerr?
Fred Smith
2004-11-13 12:28:42 UTC
Tuning DeskCNC servo drives, was Re: Anyone using JR-Kerr?
taomc57
2004-11-13 13:58:39 UTC
stepper to servo transition
Les Newell
2004-11-13 15:04:41 UTC
Re: [CAD_CAM_EDM_DRO] stepper to servo transition
Graham Stabler
2004-11-13 17:36:12 UTC
Re: stepper to servo transition
Bruce Shapiro
2004-11-15 10:53:48 UTC
Re: stepper to servo transition
Les Newell
2004-11-15 12:02:56 UTC
Re: [CAD_CAM_EDM_DRO] Re: stepper to servo transition
Bruce Shapiro
2004-11-15 16:43:20 UTC
Re: stepper to servo transition
Les Newell
2004-11-16 01:04:09 UTC
Re: [CAD_CAM_EDM_DRO] Re: stepper to servo transition