RE: [CAD_CAM_EDM_DRO] Moglice ?

How much does Moglice shrink?

Paul

-----Original Message-----
From: Dan Mauch [SMTP:dmauch@...]
Sent: Wednesday, May 17, 2000 9:39 AM
To: CAD_CAM_EDM_DRO@egroups.com
Subject: Re: [CAD_CAM_EDM_DRO] Moglice ?

A long time ago, in a place far, far away, I use to make all kind of special
laps for damaged leadscrews and gear teeth using Devcon and mixing in
abrasive compound then casting a "good section" of the area to be replicated
and then when cures used it to stone the bad area. It worked great so I see
no reason why moglice wouldn't work well as a half nut repair.
Moly-disulfide is used as anti seize compound for fasteners. It would be
interesting to mix some of the cheaper expoxies with anti seize to9 see if
it will cure properly
Dan
--


------------------------------------------------------------------------
@Backup- Protect and Access your data any time, any where on the net.
Try @Backup FREE and recieve 300 points from mypoints.com Install now:
http://click.egroups.com/1/2345/3/_/423600/_/958570770/
------------------------------------------------------------------------

Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.

Addresses:
Post message: CAD_CAM_EDM_DRO@egroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
Moderator: jmelson@... [Moderator]
URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
FAQ: http://www.ktmarketing.com/faq.html
bill,
List Manager