Re: [CAD_CAM_EDM_DRO] CADAM Capsturn/Capsmill

Bill,
These are listed as CAD/CAM programs. They out put G Code and have
Conversational input. They do not run the machine, you need a controller for
that.
Darrell

----- Original Message -----
From: <wanliker@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Thursday, May 25, 2000 6:25 AM
Subject: Re: [CAD_CAM_EDM_DRO] CADAM Capsturn/Capsmill


> In a message dated 5/25/00 6:31:33 AM Mountain Daylight Time,
> dfalck@... writes:
>
> << It had
> nice graphical output and seemed easy enough to use. I never did see a
> price
> on the product, so I went on to buy Vector instead. >>
>
> They say it is completely free, my question, is what is the output? And
how
> is it used? What do you have to use with it to use it to drive a step and
> direction controller? The output file does not seem to be DRF. or
anything I
> recognize.
> For anyone not familiar with it, it is at: www.cadem.com
> bill
>
> ------------------------------------------------------------------------
> Old school buds here:
> http://click.egroups.com/1/4057/3/_/423600/_/959261141/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>