Re: [CAD_CAM_EDM_DRO] Re: CADAM Capsturn/Capsmill

----- Original Message -----
From: D.F.S. <dfs@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Thursday, May 25, 2000 2:00 PM
Subject: Re: [CAD_CAM_EDM_DRO] Re: CADAM Capsturn/Capsmill


> But, unless I mistaken shouldn't you be able to set EMC up to accept
> that G-Code and act just like a any other controller?

You don't set EMC up to use the output from Capsturn/mill, EMC is already
set up as an Allen Bradley from what I understand. What you would do, if you
were to spend your money for these programs, is tell the program to output G
Code for an Allen Bradley and it would run fine on EMC.

>
> I plan to use EMC based on that presumption, if it is wrong I
> need to know now.
>
>